Company Dynamics

In our normal use, the oil used in the waste paper baler has very little compressibility, and the air dissolved in the oil will escape from the oil when the pressure is low, resulting in gas saturation and cavitation. So even if there is a small amount of air in the waste paper baler system, it will have a great impact on the efficiency of the waste paper baler.

1. An exhaust valve should be installed on the upper part of the cylinder of the waste paper baler to facilitate the discharge of the air in the cylinder and the system. The oil temperature change and load change that the waste paper baler adapts to are larger than those using a throttle valve. The synchronous circuit of parallel hydraulic cylinders using flow control valves has a simple structure and low cost, so it is widely used.

2. Try to prevent any pressure in the waste paper baler system from being lower than atmospheric pressure. At the same time, a particularly good sealing device should be used. If it fails, it should be replaced in time. The pipe joints and joints should be tightened with screws and cleaned in time. The oil filter at the inlet of the oil tank of the waste paper baler.

3. Always check the height of the oil level in the oil tank of the waste paper baler in daily work, and its height should be kept on the oil mark line. At the lower level, the oil suction pipe port and the oil pipe port should also be guaranteed to be below the liquid level, and must be separated by a partition. In case of accident, please stop working immediately.

The waste paper baler produced by Nick can compress and pack various cardboard boxes, waste paper, waste plastics, cartons, etc. to reduce transportation and smelting costs, https://www.nkbaler.com