When some machines are in use, you will find that it suddenly slows down, so the following points introduce why it will slow down.

1. Something blocked the suction filter, vent cap or pressure filter, or the hose was pinched;

2. The motor voltage is low; the hydraulic oil is thin or thick

3. The motor is overheated and the wiring is incorrect; the pump is overheated due to lack of oil;

4. Oil leaks or oil sprays out from the fuel tank, and the blockage of the air hole causes the pressure of the fuel tank to make the oil spray out. Clean the vent or replace the vent.

5. The control wire is broken; the motor starter is overloaded and disconnected. Press the "Reset" button on the controller;

Nick Machinery has been engaged in the production and research of horizontal hydraulic balers for more than ten years, and has rich experience in maintenance. Welcome to consult https://www.nkbaler.com.