Industry News

A metal baler is a device used to compress metal scraps, light materials, etc. into blocks for easy recycling and transportation. In order to ensure its long-term stable operation, regular maintenance is required. The following are some basic maintenance measures for metal balers:

1. Cleaning: Regularly clean metal debris, dust and oil inside and outside the baler to keep the equipment clean. Hydraulic systems and cooling systems, in particular, need to keep heat dissipation channels clear.

2. Lubrication: According to the requirements of the instruction manual, regularly lubricate the moving parts, gears, chains, etc. of the baler to reduce wear and extend service life. The selection of lubricating grease should comply with the specified model and performance.

3. Inspection: Before and after each use, check whether the fasteners are loose, the hydraulic system is leaking, and the electrical control system is working properly. Parts that are seriously worn should be replaced in time.

4. Hydraulic system: Replace the hydraulic oil regularly, usually once every 1,000 working hours. At the same time, check whether the oil pipes, oil seals, etc. are damaged to ensure stable pressure in the hydraulic system.

5. Transmission system: Check the tension of the transmission belt or chain to avoid damage caused by being too loose or too tight. Maintain good transmission efficiency.

6. Filter: The filter of the hydraulic system should be cleaned or replaced regularly to prevent oil contamination from causing system failure.

7. Operating procedures: Follow the correct operating procedures to use the baler to avoid overloading and prevent excessive wear or damage to the machine.

Through the above maintenance measures, the working efficiency and service life of the metal baler can be effectively improved, while the failure rate can also be reduced and production safety ensured.